Related Manuals for jakar SKILL TEST
Summary of Contents for jakar SKILL TEST
- Page 1 MANUFACTURER OF AMUSEMENT MACHINES JAKAR, ul. Fabryczna 10, 44-240 Żory, Poland www.jakar.pl SKILL TEST operator's manual...
-
Page 2: Table Of Contents
CONTENTS INTRODUCTION TECHNICAL PARAMETERS III SAFETY ADVICES IV PRIMARY SETUP ADVANCED SETUP VI HOW TO PUT PRIZES ON PRIZE ARMS CORRECTLY VII TYPES OF ERRORS APPEALING ON THE DISPLAY VII GUARANTEE TERMS VIII GUARANTEE CARD... -
Page 3: Technical Parameters
Components of the device are compliant with the safety standards. SKILL TEST brings to players a lot of excitement and fun. The player controls moves of a rod nailed to electronic mechanism with caterpillar track. The rod moves in horizontal and vertical direction and the player controls it using two buttons placed on the control panel. - Page 4 SOUND SETTINGS VOLUME DEMO (–/+) – a demonstration volume; VOLUME VOICE (–/+) – a voice volume; VOLUME MUSIC (–/+) – a music volume; VOLUME ALARM (–/+) – uan alarm volume; VOLUME WIN (–/+) – use DOWN / UP buttons to set winning sound volume; BASS MP3 (–/+) –...
- Page 5 COIN CHN1: 0,50 BANK CHN1: 5 Credits: 0,50 Credits: 6 COIN CHN2: 1 BANK CHN2: 10 Credits: 1 Credits: 12 COIN CHN3: 2 BANK CHN3: 20 Credits: 3 Credits: 25 COIN CHN4: 5 BANK CHN4: 50 Credits: 6 Credits: 62 1.
- Page 6 Using A, B and C buttons you should put the rod in a position, which will make the rod able to reach square-shaped hole placed below and in the center of a front. A – the rod moves to right/left side B –...
-
Page 7: How To Put Prizes On Prize Arms Correctly
After pressing GO button half-automatical calibration test starts. Every move of the rod going towards every hole and towards its starting position has to be confirmed by pressing GO button. 2) After finished calibration test on the display placed on the control panel will appear a message: CALIBRATION TEST OK 3) Turn of the device, unplugging it from the socket, and turn on again. - Page 8 4. After placing prizes reach the locking pin over hanging ties supporting prizes and screw the locking pin into the prize arm by turning it in anti-clockwise direction. 5. Pay attention to the fact, if all prizes are 6. Properly hanging prizes. hanging within a loop marked by colorful sticker.
- Page 9 2) below the locking pin and below the spiral; 3) too close to each other (on neighbouring loops); 4) below the locking pin and on the loop, but on loops non-marked with sticker.
-
Page 10: Types Of Errors Appealing On The Display
TYPES OF ERRORS APPEALING ON THE DISPLAY 1) Errors, which can occur during game mode: ERROR 1 TILT alarm is starting because of shaking the device. ERROR 2 Alarm connected with sensors (so-called sensor-award) placed within a prize basin are starting because of try of stealing prizes through this basin. ERROR 3 Sensor-award does not work (broken diods, unplugged cables etc.);...
Need help?
Do you have a question about the SKILL TEST and is the answer not in the manual?
Questions and answers