Allison And Eaton Fuller Transmission Breather Checking - freightliner BUSINESS CLASS M2 100 Maintenance Manual

Transmission
NOTE: The correct fluid level is established by
checking at the fill plug opening (manual and
automated) or the oil level dipstick (Procision).
1. On manual and automated transmssions, add
fluid until it is level with the lower edge of the fill
opening. See Fig. 1. If the transmission has two
fill openings, add fluid to the level of both fill
openings. See Table 1
lubricants. See Table 6
On Procision transmssions, add fluid through the
transmission oil dipstick tube, until the level is
within the COLD range, as marked on the dip-
stick. See Table 3 for approved transmission lu-
bricants. See Table 6
2. Check and adjust the fluid level using the appli-
cable Eaton Transmission fluid level checking
procedure in MOP 26–01.
3. Clean the fill plug (if applicable), then install it in
the transmission. Tighten the plug as follows:
• 25 to 35 lbf·ft (34 to 48 N·m) for Eaton
Fuller transmissions with 3/4-inch pipe
threads.
• 60 to 75 lbf·ft (81 to 102 N·m) for Eaton
Fuller transmissions with 1-1/4-inch pipe
threads.
Eaton Fuller Transmission Lubricant Capacities
Transmission Model
5-Speed
FS–4205A/B, FS–5205A/B
FS–6305A/B
6-Speed
FS–5406A
FS–6406A, FSO–6406A
FO–6406A, FO-8406
FSO–8406A
7-Speed
T–14607A/B
TX–14607B
9-Speed
RT–6609A
RT–8709B
Business Class M2 Maintenance Manual, March 2016
for approved transmission
for lubricant capacities.
for lubricant capacities.
*
Lubricant
†
Capacity:
qt (L)
6.25 (5.9)
9.75 (9.2)
9.75 (9.2)
9.75 (9.2)
10.5 (10.0)
9.75 (9.2)
18 (17.5)
18 (17.5)
6 (5.7)
13.0 (12.3)
Eaton Fuller Transmission Lubricant Capacities
Transmission Model
RT–8608L
10-Speed
FR–9210B
FRO–14210C, FRO–15210C
RT–8908LL
RTO–10910B AS2
RTO–11908LL
11-Speed
RTO–11909ALL
13-Speed
RTLO–14913A
18-Speed
RTLO–14918B
RTLO–16918B
Procision 7-Speed Dual Clutch
EDCO-9N107A, EDCO-6F107A
*
Quantities listed are approximate. Fill the transmission until the lubricant
is level with the bottom of the fill hole, with the vehicle in normal operating
position.
†
For models not listed in this table see the Eaton Fuller website,
w.roadranger.com.
Table 6, Eaton Fuller Transmission Lubricant
Capacities
26–03 Allison and Eaton Fuller
Transmission Breather
Checking
Transmission housing breathers (if equipped) must
remain clear. A plugged breather could result in pres-
sure build-up, which could cause oil leakage.
If the breather is plugged, clean or replace it. See
Fig. 3. Check more often if the vehicle is operating
under very dusty conditions.
26
*
Lubricant
†
Capacity:
qt (L)
13.5 (12.7)
11.75 (11)
11.75 (11)
14 (13.2)
13 (12.3)
14 (13.2)
14 (13.2)
14 (13.2)
14 (13.2)
14 (13.2)
12.7 (12)
ww-
26/5