Specified Conditions Of Use; Efficiency Test; User Groups - WellerFT Zero Smog 2 Translation Of The Original Instructions

Specified Conditions Of Use

This filtration system is suitable for the extraction and filtration of particles and gases, depending on the filter
medium used.
Warning! Danger of asphyxiation, Danger of poisoning
Improper use may result in respiratory problems, asphyxiation, poisoning or cancer
Particles and gases which are unsuitable for the filter medium in use may not be extracted.
„
Liquids and flammable gases may not be extracted
„
Never use the device without a filter or with a full filter.
„
Never use the device without the fan cover
„
This device may only be used at room temperature and indoors.
The unit is designed for use as a surface extraction unit and is not suitable for extracting fumes directly
from the soldering gun.
Intended use of the soldering station/ desoldering station also includes the requirement that you
adhere to these instructions,
„
observe all other accompanying documents,
„
comply with national accident prevention guidelines applicable at the place of use.
„
Soldering or welding enamelled wire
Use the standard prefilter (medium filter M5) and a class F7 fine dust filter when soldering and welding
„
enamelled wire
Extraction of adhesive vapours
Use a broadband gas filter (without a suspended matter filter) for the extraction of adhesive vapours.
„
The manufacturer will not be liable for unauthorised modifications to the device.

Efficiency test

In accordance with the general guidelines of the trade association, fume extractor systems must be
checked regularly, at a minimum annually, in order to ensure that they are fully functional (TRGS 528
BGETF). The efficacy test can be used to check the proper functioning of the Zero Smog solder fume
extraction units.

User groups

Due to differing degrees of risk and potential hazards, several work steps may only be performed by trained
experts.
Work step
Installation of complex pipe systems with multiple
extractor arms connected
Replacing electrical replacement parts
Specification of maintenance intervals
Operation
Filter change
Installation of complex pipe systems with multiple
extractor arms connected
Replacing electrical replacement parts
12
User groups
Specialist personnel with technical training
Electricians
Safety expert
Non-specialists
Technical trainees under the guidance and supervision
of a trained expert