ETC ECS-185/1200L User Manual page 46

GB
- Shaft locking knob (Fig. D2)
Unpacking
1 Rip fence
1 TCT Saw blade Ø 185 mm
1 Allen key
1 Set of carbon brushes
1 User manual
1 Safety instructions
Check first whether or not the product has been
damaged by transport and/or whether all the parts
are present.
Technical data
Voltage
Frequency
Power input
No load speed
Saw blade dimensions
Number of teeth
Max sawing depth 90°
Max sawing depth 45°
Weight
Lpa (sound pressure level) 91,1 dB(A) K=3dB
Lwa (sound power level)
Vibration value
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 60745; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
46
230 V
50 Hz
1200 W
5000/min.
185x20x2,4 mm
24
65 mm
43 mm
4,13 kg
102.1 dB(A) K=3dB
1.752+1,5 m/s
2
2. SAFETY INSTRUCTIONS
Explanation of the symbols
Denotes risk of personal injury, loss of
life or damage to the tool in case of non-
observance of the instructions in this
manual.
Indicates electrical shock hazard.
Keep bystanders away
Wear ear and eye protection
Wear a dust mask. Working with wood,
metals and other materials may produce
dust that is harmful to health. Do not
work with material containing asbestos
Caution! Laser beam! Never look into
the light beam and never aim the laser
at a person when it is switched on.
Danger
a) Keep hands away from cutting area and the
blade. Keep your second hand on auxiliary
handle, or motor housing. If both hands are
holding the saw, they cannot be cut by the
blade.
b) Do not reach underneath the workpiece.
The guard cannot protect you from the blade
below the workpiece.
c) Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth of the blade
teeth should be visible below the workpiece.
d) Never hold piece being cut in your hands or
across your leg. Secure the workpiece to a
stable platform. It is important to support the
work properly to minimize body exposure,
blade binding, or loss of control.
e) Hold power tool by insulated gripping surfaces
when performing an operation where the
cutting tool may contact hidden wiring or its
own cord. Contact with a "live" wire will also
make exposed metal parts of the power tool
"live" and shock the operator.