Flex CHE 2-26 SDS-plus Operating Manual page 17

CHE 2–26 SDS-plus
klqbp>
– The release button must visibly lock (jump
out) in the (drilling),
and (chiselling) positions.
– Do not switch on the electric power tool in
the position (setting the chisel position).
Setting the chisel position
The chisel can be adjusted in 9 positions
(moved 40° in each case).
 Press release button and move rotary knob
for operating mode to the
 Turn chisel until the chisel is at the required
angle (2.).
 Press release button and move rotary knob
for operating mode to the
Ensure button is locked!
Setting direction of rotation
`^rqflk>=
aç=åçí=ÅÜ~åÖÉ=çéÉê~íáåÖ=ãçÇÉ=ìåíáä=íÜÉ=
ÉäÉÅíêáÅ=éçïÉê=íççä=áë=~í=~=ëí~åÇëíáääK
 Set switch for selecting direction of rotation
to the required position:
– Left: counter-clockwise
– Right: clockwise
(hammer drilling)
symbol (1.).
symbol.
Switching on the power tool
Without locking the switch:
 Press and hold down the switch.
The electric power tool switch enables
the speed or impact rate to be increased
slowly to the maximum value.
Switch off the machine:
 Release the switch.
Locking the switch:
`^rqflk>=
Following a power failure, the switched on
electric power tool will start running again.
Immediately switch off electric power tool!
 Press and hold down switch (1.).
 Press locking button to lock the switch (2.).
17