Table of Contents
Advertisement
Available languages
Available languages
Accessories and saw blades are available
through your authorised dealer . When buying
always consider the technical requirements of this
product (see "Technical data") .
If you are not certain, ask a qualified specialist
and get advice from your trusted dealer .
NOTE
This instruction manual contains
u
information and suggestions for several
saw blades and their uses . The saw blades
depicted are not necessarily included in
the shipment, but are meant to indicate
additional possibilities for using this
product .
Suitable battery packs and chargers
Battery
Parkside 20 V battery pack
pack:
PAP 20 A1, PAP 20 A2, PAP 20 A3
Charger: Parkside 20 V charger PLG 20 A1,
PLG 20 A2, PLG 20 B1, PLG 20 A3
˜ Operation
˜ Attaching/removing the
battery pack
Removing the battery pack: Press the
¾
battery pack release button 11 . Remove the
battery pack 8 (Fig . D) .
Attaching the battery pack: Align the
¾
battery pack 8 to the handle and slide it
into it . Ensure it clicks noticeably in place .
16 GB
˜ Checking the battery pack
charging level
(Fig . B)
Check battery pack charge level: Press the
¾
button 12 . The charging level LEDs 13
light up:
LED 13
Red / orange / green
Red / orange
Red
˜ Charging the battery pack
(Fig . C)
NOTE
The battery pack 8 may be charged at
u
any time without reducing the life .
Interrupting the charging process does not
u
damage the battery pack 8 .
Charge the battery pack 8 before
¾
operation when it is at medium or low
charging level .
The charging control LEDs (green 16 and
¾
red 17) indicate the status of the charger 14
and the battery pack 8 :
LED
Red LED lights up
Green LED lights up
Green and red LED
flashing
Red LED flashing
Green LED lights up
(without battery pack)
Insert the battery pack 8 into the charger
¾
14 .
Charging level
Maximum
Medium
Low
Status
Battery pack
charges
Battery pack fully
charged
Battery pack
defective
Battery pack too
cold or too warm
Charger ready
Advertisement
Chapters
Table of Contents
