Specifications - Makita DDF448 Instruction Manual

ENGLISH (Original instructions)
1-1. Red indicator
1-2. Button
1-3. Battery cartridge
2-1. Star marking
3-1. Switch trigger
4-1. Lamp
5-1. Reversing switch lever
6-1. Speed change lever
7-1. Action mode changing ring
7-2. Arrow
8-1. Adjusting ring
8-2. Graduation

SPECIFICATIONS

Capacities
-1
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for drilling and screw driving in wood,
metal and plastic.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
8-3. Arrow
9-1. Button
9-2. LED indicator
10-1. Groove
10-2. Protrusion
10-3. Steel band
10-4. Grip base
10-5. Side grip
11-1. Sleeve
12-1. Bit holder
12-2. Bit
13-1. Groove
Model
Drilling into steel
Drilling into wood
Fastening wood screw
Fastening machine screw
High (2)
)
Low (1)
Overall length
Net weight
Rated voltage
) : 70 dB (A) or less
pA
2
) : 2.5 m/s or less
h,D
2
DDF448
13 mm
65 mm
8 mm x 75 mm
0 - 1,800
0 - 350
2.2 kg
D.C. 14.4 V
ENE034-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENG905-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
ENG900-1
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
13-2. Hook
13-3. Screw
15-1. Limit mark
16-1. Rear cover
16-2. Screws
17-1. Arm
17-2. Spring
17-3. Recessed part
18-1. Carbon brush cap
19-1. Hole
19-2. Carbon brush cap
DDF458
13 mm
76 mm
10 mm x 90 mm
6 mm
0 - 2,000
0 - 400
225 mm
2.3 kg
D.C. 18 V
ENG901-1