HIGH-PRESSURE WASHER The device is not a toy. Exercise OPERATOR MANUAL special care when using the device in the presence of children. Keep operating area clear of all per- Contents sons. HIGH-PRESSURE WASHER OPER- Do not operate the product when fa- ATOR MANUAL........
Page 3
ergizing appliance that have the Short circuit hazard! Do not insert switch on invites accidents. conductive objects (such as screw- Do not use with damaged battery drivers or similar) into the charger charger output cord or plug. If appli- plug.
Page 4
above 265 °F (130 °C) may cause Symbols on the device explosion. Charge the battery pack PS02 PS02 Store and use the charger in dry only using the original rooms only, ambient temperature charger enclosed or with a 41-104 °F (5-40 °C). charger approved by ...
Page 5
If the operator is not fluent in English, Device performance data the manufacturer’s instructions and Charging time for an warnings shall be read to and dis- empty battery cussed with the operator in the opera- Operating duration with tor’s native language by the purchaser/ a fully charged battery owner, making sure that the operator Operating pressure...
Description of the unit The maximum equipment is described in these operating instructions. Depending on the model, there are differences in the scope of delivery (see packaging). English...
Initial startup Charger 1. Place the device on a level surface. Carrying handle for device Charging socket Battery charging Power switch 1. Charge the battery. Charge level indicator Trigger gun *Conical jet nozzle for gentle cleaning *Universal brush Flat jet nozzle Water reservoir Water reservoir cap Carrying handle for water reservoir...
Page 8
1. Swing the carrying handle of the de- 4. Place the water reservoir onto the vice to the side. device. 2. Pull the water reservoir vertically in Note an upward direction. Make sure that the low-pressure hose is in the recess and is not pinched. Suck water from open containers 1.
7. Hang the suction hose with integrat- ed filter in the source of water (e.g. in a water bucket). ATTENTION Loss of valve opener and fine filter Operation of the device not possible Keep the valve opener and the fine fil- ter in the storage compartment.
Page 10
Operation with conical jet nozzle 2. Rinse off the loosened dirt with the low-pressure jet. The conical jet nozzle is suitable for gentle cleaning of fur and paws, or par- Operation with universal brush ticularly sensitive components. ATTENTION CAUTION Damage to surfaces due to dirty uni- Spray jet versal brush Injury to eyes and ears...
Transport Before carrying out any work on the device, switch it off and disconnect it CAUTION from the charger. Risk of injury and damage Cleaning the valve opener / fine Be aware of the weight of the device filter during transportation. Clean the valve opener and the fine fil- 1.
4. Remove the fine filter using the suc- The ambient temperature is outside tion hose connection or suitable pliers. the permissible range (see chapter Technical data), the motor circuit breaker has tripped. 1. Switch off the device. 2. Allow the device to cool down / heat up. 3.
Need help?
Do you have a question about the OC 3 and is the answer not in the manual?
Questions and answers