Using Tftp Via Mib Variables; Using Tftp Over Slip - Compaq Netelligent 2008 User Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-44 Administration and Management

Using TFTP via MIB Variables

You can initiate a TFTP download by setting the following repeater MIB
variables.
The firmware makes the same TFTP server request performed for the
BOOTP/TFTP download.
You can also initiate a TFTP download from the Download Firmware screen in
the VT100 interface. See the section "VT100 Management" in this chapter.

Using TFTP Over SLIP

Once a SLIP connection is made to any repeater in a Netelligent 2008/2016
repeater stack, you can use TFTP to update the Flash in any or all of the
repeaters in the stack, one at a time, as long as the repeaters are in the same
segment. To initiate the TFTP download, set the same MIB variables listed in
the previous section, "Using a TFTP Server via MIB Variables."
nws2DownloadImagePathname
image file to download and the name of the image file
nws2DownloadServerIp
nws2DownloadImageVersion
nws2DownloadState
download.
The fully qualified path name of the
The IP address of the TFTP server
The desired firmware version string
Set to downloading to initiate the TFTP