Using the Remote Control
The remote control operates the TV. To use the remote
control, point the remote control at the remote control
sensor on the front of the TV.
Use the remote control within a distance of
16.4 feet (5 meters) from the front of the TV
remote control sensor window, and within
the maximum horizontal and vertical
angles of 30 degrees.
Using universal remote controls
When you want to program a universal remote control
to operate your HP TV, if HP is not listed in the
supported brand codes, use a Philips TV code. The
HP remote control transmits Philips-licensed remote
After programming your universal remote control with
a Philips TV code, it can operate your HP TV functions
for: volume, mute, power, and input source.
Installing or replacing remote
Insert two non-rechargeable AAA batteries into the
remote control, ensuring that you place them with the
Operating the TV
Press and open the cover on the rear of the remote
Insert the batteries into the remote control, and
make sure that you match polarities.
Close the cover.
Do not mix together different types of batteries (for
example, alkaline and carbon-zinc), or old batteries
with fresh ones.
Be sure to follow the correct polarity when installing
the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
When not using the remote control for a long period of
time, remove the batteries to prevent damage or injury
from possible battery leakage.
Do not try to recharge batteries that are not intended to
be recharged; they can overheat and rupture. Follow
the battery manufacturer's directions for the batteries
you are using.
Always remove batteries as soon as they become
weak. Weak batteries can leak and severely damage
the unit. The battery life depends on how much the
remote control is used. Replace the batteries when
remote control operation becomes erratic.
Do not take apart the batteries, heat them, or throw
them into a fire.
Operating the TV