Samsung AC026MNNDKH Service Manual page 36

6 Set the SEG21 and SEG22 values:
a Set the SEG21 value by pressing the
value you want to set appears on the remote control display.
b Set the SEG22 value by pressing the
value you want to set appears on the remote control display.
When you press the
following order:
7 Press the (Mode) button. Heat and Off appear on the remote control display.
8 Set the SEG23 and SEG24 values:
a Set the SEG23 value by pressing the
value you want to set appears on the remote control display.
b Set the SEG24 value by pressing the
value you want to set appears on the remote control display.
When you press the
following order:
3 Check whether the option values that you have set are correct by pressing the
[SEG2, SEG3] [SEG4, SEG5]
[SEG14, SEG15] [SEG16, SEG17]
4 Save the option values into the indoor unit:
Point the remote control to the remote control sensor on the indoor unit and then press the
remote control twice. Make sure that this command is received by the indoor unit. When it is successfully received, you
can hear a short sound from the indoor unit. If the command is not received, press the
Samsung Electronics
Steps
(Low Fan) button repeatedly until the
(High Fan) button repeatedly until the
(Low Fan) or (High Fan) button, values appear in the
(Low Fan) button repeatedly until the
(High Fan) button repeatedly until the
(Low Fan) or (High Fan) button, values appear in the
[SEG6, SEG8] [SEG9, SEG10]
SEG17 SEG17] [SEG18, SEG20] SEG20] SEG20 [SEG21, SEG22]
SEG10 SEG10] [SEG11, SEG12]
[SEG23, SEG24] SEG24 SEG24]
Remote control display
SEG21
SEG22
SEG23
SEG24
(Mode) button repeatedly
(Power) button on the
(Power) button again.
4-5