Table of Contents
Advertisement
3 SETUP
3.1
TOOLBAR SETUP
Set the tool bar on stands approximately 30"
high for ease in assembly. Assembly should
be carried out in a flat and open area.
3.2
MARKING TOOLBAR
Find the center of the tool bar and mark it.
Mark off row spacing on both sides of center
mark. For example, if you are setting up a
cultivator for 30" rows, mark off every 30" on
both sides of center mark.
3.3
REFLECTORS
Place red reflector toward the outside edge
of the tool bar facing the rear and the yellow
reflector toward outside edge facing
forward.
3.4
THREE-POINT HITCH
Center the upper 3 pt. Hitch over the center
mark on toolbar and fasten in place with u-
bolts, lock washers and nuts. Locate pin in
upper hole for category II. Attach the lower
hitches, secure with lynch pin. Space the
lower hitches 38" apart as shown in the
figure for Cat. III.
9
Advertisement
Table of Contents
