Troubleshooting Guide - Kenwood MultiPro Sense FPM810 Series Instructions Manual

Troubleshooting Guide

Problem
The processor will not
operate.
Blender will not operate
Processor stops or slows
during processing
Weighing Function
Display screen freezes
on [- - - -]
Weight changed on display Power unit moved during
Power On light flashing
rapidly.
Power On light flashing
slowly.
Auto and Power On light
flashing.
Blender leaking from blade
assembly base.
Blender seal missing from
blade unit when removed
from packaging.
Poor performance of tools/
attachments
Cause
No Power.
No power/indicator light not lit.
Bowl not fitted to power unit
correctly.
Bowl lid not locked on correctly. Check that the lid interlock is located
Eco function operating.
Blender not locked on correctly.
Blender not assembled correctly. Check blade assembly is fully tightened into
Overload protection operated.
Processor overloaded or
overheated during operation.
Maximum capacity exceeded.
Quantity weighed too small.
operation.
Normal operation.
The light will flash if the bowl, lid
or blender are not fitted to the
power unit or not locked in place
correctly.
Normal operation.
Food processor left plugged
in for over 30 minutes without
being operated and gone into
Eco mode.
Normal operation.
The light will flash if the Auto
selected but interlocks not
engaged.
Seal missing.
Seal incorrectly fitted.
Seal damaged.
The seal is packed pre-fitted to
the blade unit.
Refer to hints in relevant 'Using the attachment' section. Check attachments
are assembled correctly.
Solution
Check processor is plugged in.
Check bowl is located correctly and the
handle is situated towards the right hand
side.
correctly into the handle area.
The processor will not work if the bowl and
lid are fitted incorrectly.
Press either the Auto Button or turn speed
control on, then return to 'O' to switch off
Eco function.
If none of the above check the fuse/circuit
breaker in your home.
The Blender will not operate if fitted
incorrectly to the interlock.
the goblet.
Switch off, unplug and allow the appliance to
cool down for approximately 15 minutes.
Refer to the usage chart for maximum
capacities to process.
Use teaspoon and tablespoon
measures for very small quantities.
Do not move the unit during use.
Zero the display before weighing next
ingredients
Check interlocks are engaged
Press either the Auto Button or turn speed
control on and then return to 'O' to switch
off Eco function.
Check interlocks are engaged correctly or press
the Auto button to switch off the Auto function.
Check seal is fitted correctly and not
damaged. To obtain a replacement seal see
"Service & customer care".
Unscrew goblet and check that seal is fitted
to blade unit.
To obtain a replacement seal see "Service &
customer care".
14
correctly.