Advertisement
TROUBLESHOOTING - SWAPPING OUT THE VENTURI JETS
1.
Remove the handle and disassemble the mixer:
3.
Unscrew the Venturi Jet using a 2.5mm Allen Key
5.
Refit the seal with silicone grease if required and then insert
disc using the long nose pliers, ensuring that the locating
pins go into the corresponding sockets.
REVERSE VIEW OF DISC
Locating pin
Locating pin
FRONT VIEW OF DISC
Patented New Zealand No. 605175
2.
4.
6.
Locating pin socket
Remove the insert disc using long nose pliers by carefully
inserting the nose of the pliers into the indicated areas A & B.
Refit the correct Venturi Jet into the insert disc and
hand tighten firmly
Reassemble mixer. Ensure that both black lines marked on the
cartridge and cartridge nut are aligned when the mixer is in full
cold position as shown in Figure 1.
AREA A
AREA B
( FULL COLD POSITION )
Figure 1.
Page 4
Advertisement
