Advertisement
Quick Links
PART LIST
DIMENSION
NO. 1
1263MM
NO. 2
1263MM
NO. 3
1080MM
NO. 3a
1080MM
NO. 4
1128MM
NO. 5
1263MM
NO. 6
775MM
NO. 7
1170MM
NO. 8
425MM
NO.9
1000MM
NO.10
1000MM
3X4M LARGE CAGE
CAGE 4M
QUANTITY
16
Box - 1
4
Box - 1
4
Box - 1
4
Box - 1
8
Box - 1
4
Box - 1
4
Box - 1
8
Box - 1
1
Box - 3
1
Box - 3
1
Box - 3
Page 1 of 7
Advertisement
Related Manuals for Feel Good 3X4M LARGE CAGE
Summary of Contents for Feel Good 3X4M LARGE CAGE
- Page 1 3X4M LARGE CAGE CAGE 4M PART LIST DIMENSION QUANTITY NO. 1 1263MM Box - 1 NO. 2 1263MM Box - 1 NO. 3 1080MM Box - 1 NO. 3a 1080MM Box - 1 NO. 4 1128MM Box - 1 NO. 5...
- Page 2 NO.11 1000MM Box - 3 NO.12 1000MM Box - 3 NO. 13 400X800MM Box - 3 LOCK Box - 3 CONNECTER AND ACCESSORIE SHEET NUMBER QUANTITY NUMBER QUANTITY Box - 3 Box - 3 Box - 3 Box - 3 Box - 3 Box - 3 Plastic tie...
- Page 3 We advise having cable ties available to help keep wire mesh in place when you are fitting it. Page 3 of 7...
- Page 4 SET UP AS BELOW ILLUSTRATION STEP I – The roof components are to be built first, poles 1 make up the sides running from front to back and the middle two horizontal bars, with poles 4 making up the sloped sides and pole 5 the front and back horizontal bars Lay all roof parts on the floor and connect like below with connector part 14 and 15 Page 4 of 7...
- Page 5 STEP II – Inserting legs Lift up one side insert tube No.3 and No.3a, leg 3 at both ends, leg 3a in the middle. STEP III Repeat step II lift up and install the other legs. STEP IV – Create ground frame Install ground tubes as below illustration –...
- Page 6 STEP IV Install door to main frame as below Illustration. Screw tube 9, 10, 11,12 to the frame, the poles already contain threads to take the screws. Please screw from the top of the frame and from underneath the frame in line with holes on tube 5, screw tube 8 in the same way. STEPVI Link the net as below illustration, and put cover on last.
- Page 7 STEPVII Roof support bar installation as below illustrations. CONSTRUCTION WARNING – MUST BE FOLLOWED TO AVOID DAMAMGE WHEN USING THE OUTDOOR COVERS. Because of the flat roof the wire mesh must be pulled as tightly as possible across the top and secured around the top edge with cable ties.