Advertisement
LCU-16/G+
1. SAFETY CAUTIONS AND WARNINGS
- The installation and handling of this equipment must be carried out by
- The current regulations require the feeder to be protected with a circuit breaker.
- The entire installation must travel at least 40 cm
- In the power supply (FA-G+):
- Do not over-tighten the screws of the terminal strip.
- Install the power supply in a dry and protected place,without risk of dripping or splashing water.
- Avoid locations near heat sources, damp or dusty.
- Do not block the ventilation slots so that air can circulate freely.
- To avoid damage, the power supply must be firmly anchored. Use a DIN 46277 guide for fixing (8 DIN).
- To avoid electric shock, do not remove the cover or handle the wires connected to the terminals.
2. CHARACTERISTICS
- TCP/IP video intercom system.
- Installtion in an existing network structure (requires the addition of D4L-G+/PoE switches) or in its own structure using fibre or
UTP cable category 5 or higher.
- Up to 98 blocks for each instqallation.
- Up to 19 door panels for each block.
- Up to 799 apartments for each block.
- Up to 19 general guard units for installation and 9 guard units for each block.
- Up to 32 ONVIF cameras.
- Up to 5 LCU-16/G+ lift controller unit groups for each block with up to 6 units for each group.
3. DEVICE DESCRIPTION
RFID Wiegand reader
connector.
RJ45 connector.
3
from any other
installation.
WIEGAND
RS485
12380616
Product Version: V01
LCU-16/G+ LIFT CONTROLLER
GOLMAR S.A.
C/ Silici, 13
08940 - SPAIN
MADE IN CHINA
Activation relay outputs..
authorised
personnel.
Connector to add more units in
parallel.
ALM_IN
ALM_OUT
PWR
RUN
IP G+
12V supply connector..
Dip-switch to
programm the
unit.
Unit reset pushbutton..
www.golmar.es
Advertisement
