Advertisement
9-EN
Super Long Life Filter
Attaching bracket F
Fix bracket F (6) onto bracket E (5) using 2 screws (13).
(Figure 10)
NOTE
• You need not attach bracket F for TCB-LF283UW.
Attaching the Super Long Life Filter
1
Turn the hanging hook of the Super Long Life Filter to the side of the electrical control box.
2
Fit the opposite side of the hanging hook onto brackets C and D, then slide the Super Long Life
Filter to the right.
3
When the hanging hooks have been fitted onto brackets A, B, and F, fix the Super Long Life Filter
using the decorative screws (12).
In addition, attach the closing plate (7) to bracket F using the decorative screws (12).
▼ Figure 11
Hanging
hook
12 Decorative
Super Long Life Filter
screws
12 Decorative screws
7 Closing plate
The decorative screws (12) are used to prevent
the filter from falling off. Tighten them firmly.
Attaching the center panel
Attach the center panel referring to the Installation Manual of the center panel.
Installation Manual
▼ Figure 10
13 Screws
5 Bracket E
6 Bracket F
Fit this onto
bracket A (1).
Super Long Life Filter
1 Bracket A
Hanging
hook
3 Bracket C
12 Decorative
screw
NOTE
• You need not attach the closing plate for
TCB-LF283UW.
• Attach the Super Long Life Filter after the
panel has been installed.
– 5 –
Super Long Life Filter
5
Changing the SET DATA (Wired remote
controller)
• Change the SET DATA when using the Super Long Life
Filter
• Before you change the SET DATA, be sure to stop the air
conditioner.
How to change the setting data
For details, refer to the Installation Manual of the 2-way cassette type (indoor unit).
Step
Push and hold the
button and theTEMP.
for about 4 seconds. The display will start flashing. Make sure that [01]
is displayed.
1
• If any code other than [01] is displayed, push the
the procedure and start again. (Operation from the remote controller
is invalid for a while after you push the
(During group control, [ALL] is displayed first. The unit number
displayed next is that of the header unit.)
UNIT LOUVER
Each time you push the
units in the group are displayed one by one. Select a unit to change its
2
SET DATA.
When you select a unit, the fan and the louver of the selected unit start
operating to show which unit is selected.
3
Use the TEMP. buttons
/
Use the TIME
/
buttons to select [0001].
4
SET DATA
Normal filter
Filter
(Factory default)
Push the
button. The setting procedure is completed when the display stops flashing and stays lit.
5
• Repeat the procedure from step
If you push the
button, all changes made to the SET DATA are cleared. Redo the procedure from step
When the setting is completed, push the
When you push the
button, the [SETTING] indicator flashes, then it
6
goes off and the unit returns to normal operation.
(Operation from the remote controller is invalid while the [SETTING]
indicator is flashing.)
4
6
1
5
2
Operation
button simultaneously
button to cancel
button.)
button, the unit numbers of the indoor
to select [5d].
0000
0001
Super Long Life Filter
2
to change the SET DATA of another unit.
button. (Setting is fixed.)
10-EN
Installation Manual
1
3
2
.
Advertisement
