Quick Start Guide - BONIS ST535 User Handbook Manual

Quick Start Guide

Switch on & wait for kiln temperature display
To run a firing program set up previously press
the ►n key
To stop the firing at any time press the ►n key
again
To review firing data press the ► key to enter the
programming mode
To change firing data press the ▲ & ▼ keys to
change the displayed value
Use the ► key again as necessary to step to the
next firing value or segment to be reviewed or
changed
To mark the end of a program set a ramp rate to
END with the ▼ key
To exit the programming mode either wait 20
seconds or press the ►n key to start firing
If the keyboard is locked then press and hold
down the fn key for 5 seconds to unlock
ST535 User Handbook Page
3