Marvel MPBV424 Owner's Manual page 8

Step 5: Assemble lock parts
Two (2) lock extensions are provided with the lock. Use
the longer extension for
shorter one for ⁄ " thick integrated panels. Assemble the
5
8
lock extension, cam stop washer, spring washer, and set
screw to the lock as shown in Figure 26 and 27.
Install this lock assembly into the lock hole in the integrated
panel and secure with the retaining nut on the back side
with a 15 mm socket and ratchet. Make sure the key slot in
the front of the lock is vertical.
BRASS EXTENSION
SPRING WASHER
NUT
LOCK
1/2 HOLE
13/16 COUNTER
BORE 7/16 DEEP
3/4 INCH
WOOD PANEL
Step 6: Install lock cam
Attach the lock cam to the back of the lock assembly with
the phillips head screw provided. Orient the lock cam verti-
cally when installing on the lock.
Spring
washer
Retainer
nut
Key
Lock
INTEGRATED PANEL INSTALLATION
⁄ " thick integrated panels and the
3
4
CAM
PHILLIPS SCREW
SECTION A-A
SCALE 1 : 1
Figure 26
Cam
Cam stop
washer
Set screw
Figure 27
Step 7: Install the door
Carefully open the top and bottom hinges on the door being
careful as there are many pinch points. Place the hinges
over the 4 screws in the cabinet, 2 at the top and 2 at the
bottom and slide the door into position. Tighten the 4 hinge
screws with a phillips screwdriver. (See Figures 25 and
25a).
Step 8: Secure the cabinet
Use the #8 x
secure the counter top to the cabinet top through the holes
in the cabinet "Z" bracket.
INNER
DOOR
Cabinet
"Z" bracket
#8 x ⁄ " black
3
4
screws
(3 places)
Screw
Brass
extension
(2 lengths
provided)
8
⁄ " black screws from the literature pack to
3
4
Figure 28