Step 7: Remove The New Battery From Its Packaging; Step 8: Place The New Battery In The Compartment; Step 9: Connect The New Battery; Step 10: Replace The Keypad - ADT QuickConnect Battery Instructions

Battery Instructions:
Ademco Lynx & ADT QuickConnect
Then tip the top of the battery up to remove it from the compartment.
Step 7:
Remove the new battery from its packaging.
C A U T I O N :
Do not remove the green plastic cover from around the new battery pack. This covering is necessary
for a proper connection and may cause serious injury or damage if removed or damaged.
Step 8:
Place the new battery in the compartment and then screw in place the plastic battery bracket.
Step 9:
Thread the wires under the retaining clips, remove the protective plastic from the connector, and plug
it into the receptacle.
Step 10:
Replace the keypad, the two tabs snap back into place, and then plug the transformer back into the
outlet.