Luxen Home WHF484 Instruction Manual

Product Name:
SKU #:
Thank you for purchasing this Luxen Home product. This product has been manufactured with the highest
standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged
parts. If any parts are missing or damaged, do not attempt to assemble or use the product.

CARTON CONTENTS:

Description
Fountain Top
Fountain Base
Pump
Compatible Pumps for this fountain:
Pump Model No.
JR250/LED
JB333/LED
YH300-70/LED
YH-LV70T
Tools required for assembly: No tools required.

Assembly Instructions:

1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. From the top of the fountain, insert the water supply tube into the pump outlet. Insert the LED connector
into the pump connector, and twist to tighten. Place the pump inside the fountain. Lead the pump power
cord out through the cord slot at the base of the fountain.
4. Make sure the water tube is properly connected with the pump, and is not crimped.
5. Add clean water into the basin. The water level should be approximately 30mm lower than the edge of the
basin.
6. Connect the power cable to outlet. If installed properly, water flow in the fountain will begin shortly.
7. Please do not use the electrical plug in wet weather conditions. Please note: On first use, there may be air in
the pump. It may take several minutes until all the air escapes.
8. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.
Aged Bronze Square 20in. H Fountain with LED Light
WHF484
Quantity
1
1
1
Contact: sales@winsomehouse.com
Instruction Manual
Please save this manual for future reference.