HP zx2000 Supplementary Manual page 46

configuring an X Server on HP-UX
Switch
–r
r
–s
–scanpci
–screen
–su
–sp
–t
–terminate
–to
–tst
ttyxx
v
–v
–verbose
–version
–weight
4–34
X Server Command Line Options (Continued)
Value Description
NA Turns off auto-repeat.
NA Turns on auto-repeat.
Minutes Sets screen-saver timeout time in minutes.
NA When this option is specified, the X Server scans the PCI
bus, and prints out some information about each device
that was detected.
ScreenID Uses the XF86Config file Screen section called
ScreenID. By default the screens referenced by the default
Layout section are used, or the first Screen section, when
there aren't any Layout sections.
NA Disables save under support on all screens.
FileName Causes the server to attempt to read and interpret
FileName as a security policy file. The file is read at server
startup and reread at each server reset. See the section
about
Number Sets pointer acceleration threshold in pixels (i.e. after how
many pixels pointer acceleration should take effect).
NA Causes the server to terminate at server reset, instead of
continuing to run. This overrides a previous
command line option.
Seconds Sets default connection timeout in seconds.
NA Disables all testing extensions (such as XTEST, XTrap,
XTestExtension1, RECORD).
NA Server started from init on
NA Sets video-off screen-saver preference.
NA Sets video-on screen-saver preference.
Level Sets the verbosity level for information printed on
stderr
is set to that value. The default verbosity level is –1.
NA Prints out the server version, patch level, release date, the
operating system/platform it was built on, and whether it
includes module loader support.
Weight Sets RGB weighting at 16 bpp. The default is 565.
security on page 4-24 for more details.
/dev/ttyxx
. When the n value is supplied, the verbosity level
–noreset
Graphics Administration Guide