Part 5 - Filling The Pool - avenli RF-21-CZ2 User Manual

PART 5 - Filling the pool

WARNING: Do not leave the pool unattended during filling.
WARNING: If more than 2.5 - 5 cm of water collects on either side before filling the
middle section. The pool is not placed on a level place! Remove the drain plug, drain all
water, completely disassemble the pool, move the pool to a flat surface and reassemble.
WARNING: Do not fill the pool with excessive water as it may collapse. During periods of
heavy rain, it is likely that some water will be drawn off to maintain the correct water
level in the pool.
1. Check that the drain hole is properly plugged and that the cap is on. Start filling the
pool with water. When there is approximately 2.5 cm of water in the bottom, stop
filling and smooth out the bends in the bottom of the pool. Around the perimeter of
the pool, pull the outer wall up past the top edge so that the pool fills evenly.
2. Continue filling the pool to the desired level.
PART 6 - Winterisation and long-term storage
WARNING: During draining, prevent children from standing under the pool facing the
drain hole. The water flow could hit children.
WARNING: The pool should be stored in a cool, dry place with no sharp objects in the
immediate area. To prevent damage, no heavy objects should be placed on the stored
pool
Step 1. If you are using a filter pump, make sure the power supply to the filter pump is
disconnected.
Step 2. Check that the drain plug is firmly seated on the side of the pool.
13