Table of Contents
Advertisement
4. This box also appears during normal system operation, if the video cable
becomes disconnected or damaged.
5. Turn Off your monitor and reconnect the video cable; then turn On both your
computer and the monitor.
If your monitor screen remains blank after you use the previous procedure, check
your video controller and computer, because your monitor is functioning properly.
Built-in diagnostics
Your monitor has a built-in diagnostic tool that helps you determine if any screen
abnormality you experience is an inherent problem with your monitor, or with your
computer and video card.
To run the built-in diagnostics:
1. Ensure that the screen is clean (no dust particles on the surface of the
screen).
2. Move and hold the joystick up/down/left/right about 4 seconds until a pop-
up menu appears.
│
60
Troubleshooting
No DP Cable
The display will go into Standby mode in 4 minutes.
www.dell.com/P2422HA
Select option:
Advertisement
Table of Contents
