Advertisement
Optional
Stepping foot control device
The height of the stepping foot above the
needle plate can be programmed at seven
different settings between 0-6 mm (1mm
increments). The height of the stepping
foot can be changed during the sewing of a
pattern if the article being sewn is not of a
uniform thickness.
Bottom plunger
This prevents the material from moving up
and down as a result of needle penetration
when using a cassette-type clamp. It is
particularly useful in preventing skipped
stitches from occurring when sewing thin
materials. It also makes sewing of
materials with small narrow edges and
sewing margins easier.
BAS-PC/300 Programming software
for electronic pattern sewer
This is a software program which creates
new sewing patterns using a personal
computer. This pattern data is saved to a
floppy disk, so that the patterns can be
sewn later simply by inserting the disk into
the pattern sewer.
Two-stage thread tension device
It is possible to set two different degrees of
thread tension for sewing a single pattern
in which there are differences in sewing
direction or material thickness, resulting in
a more beautiful finish.
Automatic bobbin changer
The bobbin is replaced automatically before
the bobbin thread runs out. This eliminates
the need to continually check the amount of
bobbin thread remaining and reduces the
number of times you need to change bobbins.
This feature is extremely useful in cases
where joining the thread is not possible, and
it increases productivity dramatically.
Milling device
This device directly uses sewing data to
create work clamps, so that the clamps
ideally suit the sewing task, and sewing is
also possible with the device still installed.
The cutting depth can be easily adjusted by
means of an adjustment dial, and the
channels in the lower and upper cassette
plates can also be changed for processing.
In addition, scraps are removed
automatically.
Jig pattern sensor
This sensor reports an error if the shape of
the work clamp is not compatible with the
programmed sewing pattern. This prevents
interruptions such as those caused by bent
needles from occurring.
Sub clamp
The sub clamp mechanism is useful when
the main clamp cannot sufficiently hold
the material by itself. The sub clamp
firmly supports the main clamp all the
time, resulting in stable and uniform
sewing (BAS-370E/375E only)
Advertisement
