Connections - Sony Jumbotron JME-UA200 Service Manual

Locations and Functions of Parts and Controls
Rear panel
SIGNAL OUT COM
1 2
1 SIGNAL OUT connector (D-sub 15-pin)
Connect a JumboTron display unit to be adjusted.
2 COM connector (D-sub 9-pin)
Connect a computer to display the data for
demonstration.
3 SENSOR connector (Half-pitch 20-pin)
Connect a sensor (not supplied).
4 AC IN connector
Connect the AC power supply of 100–240 V.
Use the supplied AC power cord which fits the AC
outlet in your area.
10
AC IN
SENSOR
3 4

Connections

Connecting a JumboTron display unit
Connect a JumboTron display unit to the SIGNAL OUT connector.
When measuring the luminance or making an automatic luminance
adjustment, connect a sensor (not supplied) to the SENSOR connector.
Be sure to turn off the power of the controller before connecting the
sensor.
SIGNAL OUT
JTU-35 JumboTron
display unit (rear)
Connecting several JumboTron display units
You can combine several units as a small screen and connect them to the
controller for a simple demonstration. Press the DEMO button on the
controller to perform demonstration. Up to 16 units can be connected.
Screen for demonstration (rear)
to 100 –240 V AC
SENSOR
Sensor (not
LDU-15 JumboTron
supplied)
display unit (rear)
SIGNAL OUT
to 100 –240 V AC
11