Table of Contents
Advertisement
Available languages
Available languages
installation
location
When selecting a position for your unit you should make sure the floor is flat and firm, and the
room is well ventilated with an average room temperature of between 10°C and 38°C. Avoid
locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight
as it may increase the electrical consumption. Extreme cold ambient temperatures may also
cause the unit not to perform properly. This unit is not designed for use in a garage or outdoor
installation. Do not drape the unit with any covering.
levelling the unit
GB
1. Adjust the two levelling feet at the front of the unit. If the unit
is not level, the doors and magnetic seal alignments will not
be covered properly.
2. Cover the bottom part by screwing the bottom cover on it
with a hexangular screwdriver until it is secured in place.
free space requirements
When installing the unit, ensure that 25 mm of free
space is left at both sides, 50 mm at the rear of
the unit and 25 mm at the top of the unit. The door
can be opened to the right or the left, depending on
which best suits the location.
Please ensure there is more than twice the width
and depth distance space of the unit to fully open
the door to a maximum angle.
10
Y mm
X mm
Y mm
X mm
Advertisement
Table of Contents
