JVC AV-32X37SUE Service Manual page 9

2.3.10 REMOVING THE CRT
Note:
• Replacement of the CRT should be performed by 2 or more
persons.
• After removing the REAR COVER, CHASSIS etc.,
(1) Putting the CRT change table on soft cloth, the CRT
change table should also be covered with such soft cloth
(shown in Fig. 4).
(2) While keeping the surface of CRT down, mount the TV set
on the CRT change table balanced will as shown in Fig. 5.
(3) Remove 4 screws marked by arrows with a box type
screwdriver as shown in Fig. 5.
Note:
Since the cabinet will drop when screws have been
removed, be sure to support the cabinet with hands.
(4) After 4 screws have been removed, put the cabinet slowly
on cloth (At this time, be carefully so as not to damage the
front surface of the cabinet) shown in Fig. 6.
Note:
• The CRT should be assembled according to the
opposite sequence of its dismounting steps.
• The CRT change table should preferably be smaller
that the CRT surface, and its height be about 35cm.
CRT CHANGE TABLE
CLOTH
Fig.4
CRT
CRT
CHANGE
TABLE
Fig.5
CABINET
Fig.6
AV-32X37SUE AV-32X37HKE
AV-32X37HIE AV-32X35HUE
AV-32X35HKE AV-32H35SUE
APPROX.
35cm
BOX
TYPE
SCREW
DRIVER
CRT
CRT
CHANGE TABLE
(No.52107)1-9