JVC AV-32X37SUE Service Manual page 28

AV-32X37SUE AV-32X37HKE
AV-32X37HIE AV-32X35HUE
AV-32X35HKE AV-32H35SUE
Measuring
Item
instrument
TRAPEZIUM Signal
adjustment generator
Remote
control unit
CORNER Signal
adjustment generator
Remote
control unit
Straight
ANGLE Signal
adjustment generator
Remote
control unit
1-28 (No.52107)
Test point Adjustment part
[4.DEF]
5.TRAPEZ
Parallel
[4.DEF]
7.COR-UP
8.COR-LO
9.COR-UP-S
10.COR-LO-S
Straight
[4.DEF]
11. ANGLE
Bring the vertical lines straight.
Description
• Set the FULL mode.
(1) Receive a cross-hatch signal.
(2) Select 5.TRAPEZ.
(3) Set the initial setting value of 5.TRAPEZ.
(4) Adjust to bring the vertical lines at the right and left
edges of the screen parallel.
(5) Press the [MENU] key and memorize the set value.
• Set the FULL mode.
(1) Select 7.COR-UP.
(2) Set the initial setting value of 7.COR.-UP.
(3) Adjust to bring the straight line at the upper corner.
(4) Select 8.COR-LO.
(5) Set the initial setting value of 8.COR-LO.
(6) Adjust to bring the straight line at the low corner.
(7) Press the [MENU] key and memorize the set value.
(8) If the extreame upper & lower corners are a little pin
or barrel chose 9.COR-UP-S or 10. COR-LO-S and
adjust.
(9) Press the [MENU] key and memorize the set value.
• In case where there is a parallelogrammical distortion of
images on the screen.
• Set the FULL mode.
(1) Select 11.ANGLE.
(2) Adjust to bring the vertical lines straight.
(3) Press the [MENU] key and memorize the set value.