Advertisement
• Do not abuse the power cord. Keep power
cords away from heat, oil, sharp edges, or
moving parts. Replace damaged power
cords immediately. Damaged power cords
increase the risk of electric shock.
• Do not operate the generator with wet
hands. Do not expose generator to rain,
snow or wet conditions. Water will increase
the risk of electric shock. The generator is
a potential source of electrical shock if not
kept dry.
• Do not attempt to connect or disconnect
load connections while standing in water,
or on wet or soggy ground.
• Do not touch electrically energized parts of
the generator and interconnecting cables
or conductors with any part of the body, or
with any non-insulated conductive object.
• Avoid body contact with earthed surfaces
such as pipes, radiators, ranges, and re-
frigerators. There is an increased risk of
electric shock if your body is earthed.
• When operating a power tool outside, use
a premium quality outdoor extension cord.
These extension cords are rated for out-
door use, and reduce the risk of electric
shock.
• Earthed tools must be plugged into an out-
let properly installed and earthed in accord-
ance with all codes and ordinances. Never
remove the earth prong or modify the plug
in any way. Do not use any adapter plugs.
• Double insulated tools are equipped with
a polarized plug where one blade is wider
fully in the outlet, reverse the plug. If it still
to install a polarized outlet. Do not change
the plug in any way. Double insulation elim-
inates the need for the three-wire earthed
power cord and earthed power supply sys-
tem.
PT3200i
• Before servicing equipment powered by
the generator, disconnect the equipment
from its power input.
• The generator must be earthed for
stallations in accordance with all relevant
electrical codes and standards before op-
eration.
• Earthing provides a low-resistance path to
carry electricity away from the user in the
event of an electrical malfunction.
• All connections and conduits from the gen-
erator to the load must only be installed
by trained and licensed electricians and
in compliance with all relevant local, state,
and federal electrical codes and standards,
and other regulations where applicable.
• Connect the generator only to a load or
electrical system (230 volt) that is compat-
ible with the electrical characteristics and
rated capacities of the generator.
• NEVER try to power building or home wir-
ing by plugging the generator into a wall
outlet, a practice known as "backfeeding."
This is extremely dangerous and presents
an electrocution risk to utility workers and
neighbours served by the same utility
transformer. It also bypasses some of the
built-in household circuit protection devic-
es.
www.powertec.net.nz
3000W DIGITAL
INVERTER GENERATOR
-
8.
Advertisement
