Mounting the door panel on the vehicle doors Panel mounting on the vehicle doors Loudspeaker connection Loudspeaker connection -wiring diagram Mounting the speaker covers Technical information Service Troubleshooting Warranty Jehnert Sound Design I Im Michelreis 14 I 72124 Pliezhausen I phone: 07127-93457-0 I sounddesign@jehnert.de I www.jehnert.de...
The products were carefully packed and checked for completeness. In the event of shortages, damage or defects please refer to our warranty on the back of these assembly instructions. Jehnert Sound Design I Im Michelreis 14 I 72124 Pliezhausen I phone: 07127-93457-0 I sounddesign@jehnert.de I www.jehnert.de...
If the sealing foil on the inner door panel is damaged, it must be replaced before the be replaced before the door panel is installed. Jehnert Sound Design I Im Michelreis 14 I 72124 Pliezhausen I phone: 07127-93457-0 I sounddesign@jehnert.de I www.jehnert.de...
NOTE RETROFITTING: The panel dimensions are identical to the original card pocket. This makes a very simple and problem-free later retro tting is possible. Jehnert Sound Design I Im Michelreis 14 I 72124 Pliezhausen I phone: 07127-93457-0 I sounddesign@jehnert.de I www.jehnert.de...
3.5 Remove the panel again. Mark the cutouts for the speaker openings (see illustration) on the door panel using a jigsaw. Cutouts vehicle door for woofer Cutouts for woofer ready mounted Jehnert Sound Design I Im Michelreis 14 I 72124 Pliezhausen I phone: 07127-93457-0 I sounddesign@jehnert.de I www.jehnert.de...
Door panel inside *Outer door panel = Rear door panel inside Fig.: Example of a vehicle door - insulation with bitumen mats / tar mats Jehnert Sound Design I Im Michelreis 14 I 72124 Pliezhausen I phone: 07127-93457-0 I sounddesign@jehnert.de I www.jehnert.de...
5.3. midrange/tweeter mounting in the dashboard: Insert midrange/tweeter with the supplied adapter rings in the dashboard instead of the factory speaker. 4x 3.9x16 Lens head Jehnert Sound Design I Im Michelreis 14 I 72124 Pliezhausen I phone: 07127-93457-0 I sounddesign@jehnert.de I www.jehnert.de...
(see illustration), screw the supplied sheet metal screw 3.9 x 13 through the door panel into the inner door panel. Sheet metal screw 3,9x13 Jehnert Sound Design I Im Michelreis 14 I 72124 Pliezhausen I phone: 07127-93457-0 I sounddesign@jehnert.de I www.jehnert.de...
-> TV B =predrill + large washer + M4 M4x 70 3,9 x19 M4x 45 Lens head small washer Jehnert Sound Design I Im Michelreis 14 I 72124 Pliezhausen I phone: 07127-93457-0 I sounddesign@jehnert.de I www.jehnert.de...
9 V battery All woofers must resonate evenly during this check! A bass driver with reversed polarity can cancel out the entire bass response! Jehnert Sound Design I Im Michelreis 14 I 72124 Pliezhausen I phone: 07127-93457-0 I sounddesign@jehnert.de I www.jehnert.de...
Velcro fasteners. CAUTION: Please avoid any kind of „ forcible tearing „ on the diaphragms (risk of breakage !) Jehnert Sound Design I Im Michelreis 14 I 72124 Pliezhausen I phone: 07127-93457-0 I sounddesign@jehnert.de I www.jehnert.de...
Power handling continuous / music: 2 x 150/200Watt Frequency range: 35-22.000 Hz Impedance: 2 Ohm We reserve the right to make changes in the interest of technical progress. Jehnert Sound Design I Im Michelreis 14 I 72124 Pliezhausen I phone: 07127-93457-0 I sounddesign@jehnert.de I www.jehnert.de...
Mounting the panels on the TV ( page 7) Covers do not adhere Observe notes page 12 Vibration noise Insulation see notes page 6 Jehnert Sound Design I Im Michelreis 14 I 72124 Pliezhausen I phone: 07127-93457-0 I sounddesign@jehnert.de I www.jehnert.de...
JEHNERT Sound Design »Development and production of car audio systems« Inh. Hans-Peter Jehnert Im Michelreis 14 72124 Pliezhausen Tel.: 07127-93457-0 Fax: 07127-93457-10 sounddesign@jehnert.de www.jehnert.de Jehnert Sound Design I Im Michelreis 14 I 72124 Pliezhausen I phone: 07127-93457-0 I sounddesign@jehnert.de I www.jehnert.de...