Robertshaw RS6000 User Manual page 10

CYCL = Cycle Timer allows a compressor to rest between cycles. Can be
set from 0 to 5 minutes in 1 min increments.
 WARNING:Awrongshortcyclesettingcan
damageyourequipment.Thisshouldonly
bechangedbyatrainedHVACprofessional.
CAL = Calibration offset. Changes the displayed temperature from the
actual temperature by +3 to -3 degrees in one degree increments.
Increasing the offset by +2 will cause the thermostat to display
a temperature that is 2 degrees higher than the actual room
temperature
CreatingaPassword–ProtecttheSettings
The buttons on the front of the thermostat can be locked with a password.
To create a password:
1. Press the
5 seconds.
You will be asked for a 4 digit password.
2. Each digit is set using the
move to the next digit and to save the password after the 4th digit is
entered. Press
3. The password is saved after 5 seconds.
All of the front buttons are now locked out until the password is entered.
Pressing any button will cause
To unlock the buttons:
1. Push and hold the
request for password is displayed.
2. Enter the digits for the password by pressing the
buttons. Press the
password after the 4th digit is entered. Press
3. When the correct password is set, wait for 5 seconds to unlock
the system.
4. If the wrong password is entered the display will flash ---- for 5
seconds then return to normal.
Once the security has been disabled, a password needs to be recreated
to protect the settings.
and buttons at the same time and hold them in for
to move back.
to flash.
and
to move to the next digit and to save the
and buttons. Press the
buttons for 5 seconds until the
10
to
and
to move back.