Table of Contents
Advertisement
Fault
Creasing.
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
Detergent residue on
the damp washing.
Cause and troubleshooting
The spin speed is too high.
The next time you run a wash cycle, set a lower
▶
spin speed.
The load is too large.
The next time you run a wash cycle, reduce the
▶
amount of laundry being loaded.
Unsuitable programme for the type of fabric.
Select the programmes that are suitable for the
▶
type of fabric.
A low spin speed is selected.
The next time you run a wash cycle, set a higher
▶
spin speed.
Start the odstředění programme.
▶
Easy-Iron is activated.
Select the programmes that are suitable for the
▶
type of fabric.
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the odstředění programme.
▶
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the odstředění programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Start the máchání programme.
▶
Troubleshooting en
55
Advertisement
Table of Contents
