Table of Contents
Advertisement
Fault
"E:30 / -80"
"E:36 / -25 / -26"
"E:38 / -25 / -26"
i-DOS error, deactiv-
ate i-DOS
All other error codes.
Water cooling
"E:30/-20"
Cause and troubleshooting
Unapproved extension installed on the water drain
hose.
Remove any unapproved extensions from the water
▶
hose. Connecting the appliance
The pump cap is not fully screwed in.
Ensure that the pump cap is screwed in all the way
▶
into the appliance. The handle on the pump cap
must be in a vertical position.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 44
▶
Drain pump is blocked.
→ "Cleaning the drum", Page 42
▶
if the fault is displayed again,
→ "Cleaning the drain pump", Page 44
▶
Inlet opening of the rubber gasket is blocked.
→ "Cleaning the intake opening in the rubber gas-
▶
ket", Page 47
The pump for the intelligent dosing system is blocked.
Switch off the appliance.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer", Page 43
If this display appears again, call customer service.
3.
→ "Customer Service", Page 59
Note: You can start the washing programme if you de-
activate the intelligent dosing system and dose manu-
ally.
→ "Buttons", Page 25
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 59
To protect the wastewater pipes, the hot detergent
solution is cooled before being drained.
Wait until the detergent solution has cooled down.
▶
Solenoid valve defective.
Call the after-sales service.
▶
→ "Customer Service", Page 59
Detergent dosage is too high.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
Additional water is added.
Troubleshooting en
49
Advertisement
Table of Contents
