Maintenance And Cleaning - INSIGHT Vital Signs Plus ECG Operator's Manual

Physiological Alarm
Notification
SpO2 too high
SpO2 too low
PR too high
PR too low
Technical Alarm
Notification
System
Error3/SysErr3
System
Erro4/SysErr4
No Sensor
Sensor off
Tips (including general warnings)
Notification
No pulse
Searching

7.5 Maintenance and Cleaning

Warning
Before cleaning the monitor or sensor, turn off the power and disconnect the AC
power.
Warning
Do not autoclave the sensor.
Do not immerse the sensor in liquid,
If the sensor or cable has signs of damage or deterioration, it is forbidden to use
again.
Cleaning:
The surface of the sensor can be wiped with cotton ball or soft cloth dipped with
medical alcohol, and then dried with dry cloth. The light emitting tube and the
receiver part of the sensor can be cleaned in the same way.
The cable can be cleaned and disinfected with 3% hydrogen peroxide or 70%
isopropanol. The connector cannot be immersed in the above solution.
Reason
SpO2 measured is higher than the upper alarm limit
SpO2 measured is below the lower alarm limit
PR measured is higher than the upper alarm limit
PR measured is below the lower alarm limit
Reason
Self-test failure of blood
oxygen module
Blood oxygen
communication error
Sensor not connected
Sensor switched off
Reason
No pulse was found
Searching for a pulse
Solution
Contact Woodley Equipment
Company.
module Contact Woodley Equipment
Company.
Make sure that the sensor is
placed on the animal's tongue
or ear and that the monitor is
connected
properly.
39
to the cable