Gbe Interconnect Switch; Regulatory Compliance Notices; Regulatory Compliance Identification Numbers; Federal Communications Commission Notice - HP ProLiant xw25p User Manual

Proliant bl p-class system diagnostic station

Hide thumbs Also See for ProLiant xw25p:

Table of Contents

GbE Interconnect Switch

You can configure or troubleshoot a GbE interconnect switch in an out-of-rack

environment. In this situation, the diagnostic station provides power to the

interconnect switch. Use the following items from the diagnostic station kit:

Diagnostic station

DC power cord (for interconnect switch)

Network cable with RJ-45 connectors

AC power cord

For setup and operating instructions, refer to the documentation that ships with the

interconnect switch.

For the purpose of regulatory compliance certifications and identification, your

product has been assigned a unique HP series number. The series number can be

found on the product nameplate label, along with all required approval markings and

information. When requesting compliance information for this product, always refer

to this series number. The series number should not be confused with the marketing

name or model number of the product.

This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference when the equipment is

operated in a commercial environment. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. Operation of

this equipment in a residential area is likely to cause harmful interference, in which

case the user will be required to correct the interference at personal expense.

HP ProLiant BL p-Class System Diagnostic Station User Guide

Table of Contents

Proliant bl p-class