Related Manuals for EMP E2512A
Summary of Contents for EMP E2512A
- Page 1 Installation Manual Installation Manual E2512A & WP29 WP29 Electric Water Pump Electric Water Pump Part Number Serial Number(s) 1030002xxx E2512A LPE Rev A, 2-May-2013 9970002204 WP29 , REV E, 4/16/2012 © 2010 EMP...
- Page 2 The information and specifications contained throughout this manual are up to date at the time of publication. EMP reserves the right to change the content of this manual at anytime without notice...
-
Page 3: Table Of Contents
Electrical Specifications........................10 Parts List ............................. 11 Schematics ............................11 Controller Connectors ......................... 13 Wire Connections..........................13 Installation............................14 Pump Orientation ..........................14 Plumbing ............................15 Troubleshooting ..........................16 LPE Rev A, 2-May-2013 9970002204 , REV E, 4/16/2012 © 2011 EMP... -
Page 4: Safety
THIS SYMBOL IS USED TO ALERT YOU TO A CONDITION OR PRACTICE THAT CAN CAUSE DAMAGE TO THE WP29 OR THE VEHICLE, OR BOTH. NOTE: Is used to provide additional information that requires special attention by the technician. LPE Rev A, 2-May-2013 9970002204 , REV E, 4/16/2012 © 2011 EMP... -
Page 5: Product Safety Warnings
% &' " ! 123 )3 7&8999:979 A block-off plug is supplied with this pump :& for use when this connector is not used (traditional on/off control wiring configuration). LPE Rev A, 2-May-2013 9970002204 , REV E, 4/16/2012 © 2011 EMP... -
Page 6: Specifications
Specifications Specifications Dimensions Hole Locations/Bolt Spacing LPE Rev A, 2-May-2013 9970002204 , REV E, 4/16/2012 © 2011 EMP... -
Page 7: Mounting Screws
When making the inlet and outlet hose connections to the pump it is strongly recommended to use SAE20CT worm drive type hose clamps. Torque worm drive clamps to 70 +/-10 in lbs. Spring type clamps are not recommended. LPE Rev A, 2-May-2013 9970002204 , REV E, 4/16/2012 © 2011 EMP... - Page 8 Bar Code Serial Number Hardware Part Number Country of Origin EMP Programmed Assembly Number or Customer Part Number Software Calibration Number Customer optional Figure 1: Part Label information LPE Rev A, 2-May-2013 9970002204 , REV E, 4/16/2012 © 2011 EMP...
-
Page 9: Operating Range
&8>°* -:&8°1/ @;9°* -@;9°1/ :>;9 4! Coolant Recommendation " " " " #$ % " " & '() " " " " " " " " " " LPE Rev A, 2-May-2013 9970002204 , REV E, 4/16/2012 © 2011 EMP... -
Page 10: Electrical Specifications
3ft in length (very low source impedance). Anything done in the application to increase the source impedance will have a significant (downward) impact on these numbers. This current is not generated every time the motor is started, but only when the ignition line is first applied. LPE Rev A, 2-May-2013 9970002204 , REV E, 4/16/2012 © 2011 EMP... -
Page 11: Parts List
7 A 4 0!25 D3( 7 A C2 ; A 4 0!25 E ; @ !D3! ! 3 8 A 4 0!25 0E 6 A 1235 Figure 2 Controller connectors LPE Rev A, 2-May-2013 9970002204 , REV E, 4/16/2012 © 2011 EMP... - Page 12 If CAN or Serial TTL control is not used the 6 pin DTM connector must be blocked off to prevent entry of water or dirt which will result in damage to the pump. A block off plug EMP P/N 3250001030...
-
Page 13: Controller Connectors
DFS (default harnesses. speed) • In the absence of CAN the pump will run See the online Technical documentation or • at DFS call EMP Technical Support for detailed information about Serial implementation and messaging. LPE Rev A, 2-May-2013 9970002204 , REV E, 4/16/2012 ©... -
Page 14: Installation
Installation Installation Pump Orientation Preferred Orientation Acceptable Orientation (View From Front of Pump) LPE Rev A, 2-May-2013 9970002204 , REV E, 4/16/2012 © 2011 EMP... -
Page 15: Plumbing
Pump Inlet must be plumbed using 1.0”Dia. hose or thin walled tubing. • Up to 1” length of 0.75” dia is permissible Deviations from this requirement must be approved by EMP • Please contact EMP customer service for application review •... -
Page 16: Troubleshooting
Troubleshooting Troubleshooting • 1 • 1 • 1 • ? • 1 • 1 • • 1 • 1 • 1 • ? • ? LPE Rev A, 2-May-2013 9970002204 , REV E, 4/16/2012 © 2011 EMP... - Page 17 Flow (GPM)
Need help?
Do you have a question about the E2512A and is the answer not in the manual?
Questions and answers