Before The First Fire; Operating Instructions - Travis Industries Fire Garden 94900432 Manual

Before the First Fire

!
Read this entire manual before you use your new appliance, especially the section "Safety Precautions"
on page 4. Failure to follow the instructions may result in property damage, bodily injury, or even death.
!
Remove any cover from the appliance prior to operation.
!
Inspect the appliance to make sure it is free of debris or objects that may have fallen into the appliance
prior to operation.
!
Inspect the appliance, burner, and supply lines for any damage prior to operation. The burner must be
replaced prior to the appliance being put into operation if it is evident that the burner is damaged. Use
only Travis Industries replacement burners.
!
It may be difficult to see the burner operating in direct sunlight.

Operating Instructions

WARNING: This gas appliance is automated, it runs off an electric ignition system and may not be lit
with a lighter or matches.
How your appliance works
Ignition
When you switch the appliance on, electrical power is supplied to the control module, starting the ignition
sequence. During ignition, the igniter will heat up. Gas is then turned on to the appliance. The appliance will
ignite and the thermopile will signal the control module that the appliance is lit and the igniter will then turn off.
NOTE: In rare cases, the appliance will fail to light. In these cases, the appliance will wait 30 seconds, then re-
start the 30-second ignition sequence. The control module will try to re-start the appliance a total of 3 times. If it
fails to light after three tries, the appliance will then shut off. To re-start, turn the switch off, wait 5 minutes, then
turn the switch on.
Appliance in Operation
The appliance, once lit, will stay lit until the switch is turned off. If the gas flow is interrupted, or if wind blows out
the flame, the appliance will start the ignition sequence. If you cycle power to a hot appliance (turn off and back
on) it may take up to 1-1/2 minutes for it to relight.
Safety Circuit
Each appliance has a built-in safety circuit that only allows gas to flow during the ignition sequence and when the
appliance is lit. This prevents gas build-up. The safety circuit relies upon a thermopile to keep the gas valve
open. If the flame goes out the control module will shut the gas off then try to relight the appliance. Your
appliance can not be operated manually, if a problem persists consult the troubleshooting guide (pg. 34) and call
a qualified service technician if needed.
© Travis Industries, Inc.
Operation
5/24/22 - 1579 Outdoor Complete Linear Fire Pits
27