Travis Industries Fire Garden 94900432 Manual page 17

Installation

Use wire nuts to
connect the wires from
the 24VAC transformer
to the yellow and the
yellow/white striped
wires on the control
module (polarity does
not matter for this
connection). When the
connections are secure,
coil the wires and push
them back into the
electrical box.

Reinstall the media tray cover and pilot shield
and secure it to the appliance with the two
screws removed in the first step.

The appliance uses approximately 40 watts during startup (1.6 amps at 24 VAC). Make sure the circuit
and wires are sized appropriately. The appliance requires a minimum of 22 VAC to operate (if the voltage
drops below this, the appliance may not start).
© Travis Industries, Inc.
(qualified installers only)
5/24/22 - 1579 Outdoor Complete Linear Fire Pits
17