Table of Contents
Advertisement
Available languages
Available languages
5
13
6
15
7
17
8
INSTALLING THE HOPPER SIDE HANDLE
PARTS REQUIRED:
1
x
Hopper Side Handle (#13)
INSTALLATION:
•
Remove the two pre-installed screws, locking washers, and washers from the
Hopper Side Handle pins (on the hopper itself).
•
Next, place the Hopper Side Handle over the positioning pins. Take one screw,
add a locking washer and a washer, then hand-tighten the screw (from below
the pin) into the Hopper Side Handle.
NOTE: DO NOT OVER-TIGHTEN THE SCREWS.
•
Repeat the same installation for the other end of the Hopper Side Handle.
INSTALLING THE LID HANDLE
PARTS REQUIRED:
16
2
x
Lid Handle Washer (#14)
2
x
Lid Handle Bezel (#15)
1
x
Lid Handle (#16)
14
INSTALLATION:
•
Remove the two pre-installed screws, locking washers, and washers from the
Lid Handle.
•
Take one screw, add a locking washer and a washer, then from inside the Main
Barrel lid, protrude the screw to the outside. Add a waster and a bezel on the
screw, then hand-tighten the screw (from the inside) into the Lid Handle.
NOTE: DO NOT OVER-TIGHTEN THE SCREWS.
•
Repeat the same installation for the other end of the Lid Handle.
INSTALLING THE FRONT SHELF
PARTS REQUIRED:
1
x
Front Shelf (#17)
INSTALLATION:
•
Insert the mounting brackets of the Front Shelf into the mounting holes on the
front skirt of the grill.
INSTALLING THE BURN GRATE
PARTS REQUIRED:
1
x
Burn Grate (#7)
INSTALLATION:
7
•
Insert the burn grate into the burn pot. The hole in the burn grate should align
and be open for the igniter to light the pellets. To verify proper positioning,
ensure the curved lip of the burn grate is flush with the top of the burn pot, and
the notched side should be flush under the fuel deflector.
IMPORTANT: PROPER PLACEMENT AND MAINTENANCE OF THE BURN GRATE IS
VITAL TO THE USE OF THE UNIT.
www.louisiana-grills.com
5
Advertisement
Table of Contents
