Louisiana Grills FOUNDERS Series Assembly Manual page 4

4
2
18
3
21B
21A
22B
22A
4
LOUISIANA GRILLS
12
SECURING THE BOTTOM SHELF
PARTS REQUIRED:
1 x Bottom Shelf (#18)
16 x Screw (#A)
16 x Washer (#B)
16 x Locking Washer (#C)
INSTALLATION:
• From underneath, secure the Bottom Shelf to each support leg using four
Washers, Locking Washers, and Screws. Ensure the flat surface of the Bottom
Shelf is facing up towards the Main Barrel.
NOTE: TIGHTEN ALL SCREWS COMPLETELY, INCLUDING SCREWS THAT WERE
INSTALLED IN PREVIOUS STEP.
MOUNTING WHEELS TO THE LEGS
PARTS REQUIRED:
2 x Caster Wheel (#21)
2 x Locking Caster Wheel (#22)
12 x Washer (#B)
12 x Locking Washer (#C)
12 x Screw (#D)
INSTALLATION:
• Mount one Locking Caster Wheel to the floor end of the Bottom Shelf using
three Washers, Locking Washers, and Screws, through the pre-drilled holes.
Continue to install the other Locking Caster Wheel to the other floor end of
the Bottom Shelf.
IMPORTANT: LOCK THE LOCKING CASTER WHEELS.
• Repeat the same installation for the two Caster Wheels into the hopper end
of the Bottom Shelf.
• Once the wheels are all secure, carefully lift the grill into an upright position.
INSTALLING THE HOPPER LID HANDLE
PARTS REQUIRED:
1 x Hopper Lid Handle (#12)
INSTALLATION:
• Remove the two pre-installed screws from the Hopper Lid Handle. From inside
the Hopper Lid, insert one screw to protrude to the outside, then hand- tighten
the screw (from the inside) into the Hopper Lid Handle.
NOTE: DO NOT OVER-TIGHTEN THE SCREWS.
• Repeat the same installation for the other end of the Hopper Lid Handle.