Advertisement
Available languages
Available languages
EN
5. During the charging process, one of the four blue LEDs of the status indicator (7) flashes.
6. When the charging process has finished, disconnect the USB cable (11) from the coaxial port. When the Li-ion battery is fully charged, all four blue LEDs in
the status indicator (7) light up continually.
7. Close the protective cover covering the connection ports (6).
Charge the portable lamp following each period of use or every three months.
The portable lamp only fulfils the requirements of the type of protection specified when the protective cover covering the connection ports (6) is closed.
Operating the Portable Lamp
The portable lamp can operate in the following three operating modes which are selected by pressing the press switch (5).
The switching cycle of the portable lamp operating modes is as follows:
Operating mode 1 → Operating mode 2 → Operating mode 3 → Off
Operating mode 1
Operating mode 2
Operating mode 3
Press the press switch (5) as often as necessary until the required mode is activated.
Dimming Function
The portable lamp is provided with a dimming function. You can adjust the brightness in any operating mode.
1. Press the press switch (5) to switch the portable lamp on and select the operating mode required.
2. Press and hold the press switch (5) to adjust the brightness.
After a brief flash sequence, the brightness is reduced continuously. On reaching the minimum brightness, the portable lamp flashes briefly again and the
brightness is continuously increased.
3. Release the press switch (5) on reaching the required brightness.
Powerbank Function
The portable lamp is provided with a powerbank function to charge mobile devices via USB.
1. Open the protective cover covering the connection ports (6).
Underneath is one port for a coaxial plug and one USB-A port.
2. Connect the device to be charged to the USB-A port using a USB cable. During the charging process, the four blue LEDs of the status indicator (7) light up.
3. Disconnect the USB cable from the micro USB-A connector when the charging process has finished.
4. Close the protective cover covering the connection ports (6).
The portable lamp only fulfils the requirements of the type of protection specified when the protective cover covering the connection ports (6) is closed.
Magnet Function
You can use the magnet (1) in the base or magnets (4) on the rear to fix the portable lamp to steel surfaced parts.
If you use the magnet (1) in the base, you can align the portable lamp by pivoting it on the base (2).
Using the Hooks
The portable lamp is equipped with two hooks (3) on the rear. The hooks (3) can be hinged out and turned in any direction.
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of the
products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line with similar features and may not be
included in the product you just acquired.
* Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses
or for equivalent purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and special adjustments, must only be carried out by
technicians of the authorized service department of the manufacturer.
3
Working light energy-save mode (50% mode 1 brightness)
Working light (100% brightness)
Spotlight
WWW.BORMANNTOOLS.COM
Advertisement
