Subscribe to Our Youtube Channel
Related Manuals for Anaheim Automation ENC-M9I Series
Summary of Contents for Anaheim Automation ENC-M9I Series
- Page 1 ENC-M9I Series Assembly Instructions Guide ENC-M9I Series Assembly Instructions Guide L011952 Tel. (714) 992-6990 www.anaheimautomation.com 4985 East Landon Drive Anaheim, CA 92807 Fax. (714) 992-0471...
- Page 2 Attention - Electrostatic Sensitive Device Observe precautions during handling and installation Step 1: • Make sure the encoder mountng surface is flat and clean. • Place the supplied spacer on the motor. • Set the ENC-M9I sensor board on the spacer and secure to the motor housing using two M2.5 x 0.45 x 8. Apply a very small amount of Loctite 222 or 242 only to the threaded end of the screws and loosely install. (Loctite datasheet suggests potential chemical compatibility issues with thermoplastics). The recommended height for the screw head is 1 mm. Do not tighen the screws completely at this time. Tel. (714) 992-6990 www.anaheimautomation.com 4985 East Landon Drive Anaheim, CA 92807 Fax.
- Page 3 Step 2: • Slide the alignment tool down the motor shaft with the cone end towards the ENC-M9I. • Slightly rotate the ENC-M9I encoder as needed and center the encoder by lightly pushing the alignment tool into the center hole of the encoder. • Tighten the screws to secure the encoder to the motor housing. • Maintain a constant pressure on the alignment tool while tightening the screws. • The maximum recommended torque for the mounting screws is 0.28 N-m (40 oz-in). • Remove the alignment tool. Tel. (714) 992-6990 www.anaheimautomation.com 4985 East Landon Drive Anaheim, CA 92807 Fax. (714) 992-0471...
- Page 4 Step 3: • Slide the ENC-M9I magnetic target down the shaft. • Position the air gap shim between the top of the MPS160 ASIC and the magnet material on the magnetic target. • Using the supplied 1.5 mm hex wrench, tighten the set screw on the magnetic target to a maximum torque of 0.71 N-m (100 oz-in). • Remove the air gap shim. Caution Failure to observe the following caution could create a risk of serious injury. Insufficient tightening of the set screws may result in encoder wheel coming off the shaft.
- Page 5 Step 4: • Connect the ENC-M9I cable before the plastic cover is installed. • Place the plastic cover over the ENC-M9I and lightly press down towards the motor until it snaps on the ENC-M9I plastic base. Make sure to properly align the opening on the cover with the ENC-M9I cable connector. 4985 East Landon Drive Anaheim, CA 92807 Tel. (714) 992-6990 Fax. (714) 992-0471 www.anaheimautomation.com...
- Page 6 Plastic Cover ENC-M9I Magnetic Target Hex Wrench Plastic Shim M2.5 Mounting Screws ENC-M9I Board ENC-M9I Plastic Base ENC-M9I Cable Pin Number Function Wire Color Pin 1 Pin 2 Ground Black Pin 3 Yellow Pin 4 Yellow/White Pin 5 Blue Pin 6 Blue/White Pin 7 Index+ Orange Pin 8 Index- Orange/White Tel.
Need help?
Do you have a question about the ENC-M9I Series and is the answer not in the manual?
Questions and answers