Subscribe to Our Youtube Channel
Related Manuals for Anaheim Automation ENC-M11I Series
Summary of Contents for Anaheim Automation ENC-M11I Series
- Page 1 ENC-M11I Series Assembly Instructions Guide ENC-M11I Series Assembly Instructions Guide L011953 Tel. (714) 992-6990 www.anaheimautomation.com 4985 East Landon Drive Anaheim, CA 92807 Fax. (714) 992-0471...
- Page 2 Step 1: • Make sure the encoder mountng surface is flat and clean. • Place the supplied spacer on the motor. • Set the ENC-M11I sensor board on the spacer and secure to the motor housing using two M2.5 x 0.45 x 8. The recommended height for the screw head is 1 mm. Do not tighen the screws completely at this time.
- Page 3 Step 2: • Slide the alignment tool down the motor shaft with the cone end towards the ENC-M11I. • Slightly rotate the ENC-M11I encoder as needed and center the encoder by lightly pushing the alignment tool into the center hole of the encoder. • Tighten the screws to secure the encoder to the motor housing. • Maintain a constant pressure on the alignment tool while tightening the screws. • Remove the alignment tool. Tel. (714) 992-6990 www.anaheimautomation.com 4985 East Landon Drive Anaheim, CA 92807 Fax. (714) 992-0471...
- Page 4 Step 3: • Slide the ENC-M11I magnetic target down the shaft. • Position the air gap shim between the top of the MPS160 ASIC and the magnet material on the magnetic target. • Using the supplied 1.5 mm hex wrench, tighten the set screw on the magnetic target to a maximum torque of 3.9 kgf-cm. • Remove the air gap shim. 4985 East Landon Drive Anaheim, CA 92807 Tel. (714) 992-6990 Fax. (714) 992-0471 www.anaheimautomation.com...
- Page 5 Step 4: • Place the plastic cover over the ENC-M11I and lightly press down towards the motor until it snaps on the ENC-M11I sensor board. Make sure to properly align the opening on the cover with the ENC-M11I connector. 4985 East Landon Drive Anaheim, CA 92807 Tel. (714) 992-6990 Fax. (714) 992-0471 www.anaheimautomation.com...
- Page 6 Plastic Cover Hex Wrench Magnetic Target Air Gap Shim Alignment Tool Sensor Board Plastic Spacer Pin Number Function Color 15 Pin Color 8 Pin Pin 1 Yellow Yellow Pin 2 Yellow/White White Pin 3 Blue Blue Pin 4 Blue/White Green Pin 5 Index+ Orange Orange Pin 6 Index- Orange/White Brown Pin 7...
Need help?
Do you have a question about the ENC-M11I Series and is the answer not in the manual?
Questions and answers