Advertisement
ENC-AMT10 Series Assembly
Instructions Guide
Step 1
1. Insert Tool A as a spacer that defines the distance to the
mounting surface.
2. Slide appropriate sized Sleeve over shaft all the way
down to Tool A.
3. Slide Shaft Adapter over Sleeve.
4. Use Tool B to press Shaft Adapter over Sleeve until flush
with Tool A.
Step 2
1. Remove Tools A and B.
2. Place Base on motor, with Tool B used as a centering
tool.
Step 3
1. Align Tool B with flange on Base.
2. Slide Base and Tool B onto motor, centering onto the
Shaft Adapter.
L011745
4985 East Landon Drive Anaheim, CA 92807
Tel. (714) 992-6990
Fax. (714) 992-0471
www.anaheimautomation.com
Advertisement
Table of Contents
Related Manuals for Anaheim Automation ENC-AMT10 Series
Summary of Contents for Anaheim Automation ENC-AMT10 Series
- Page 1 ENC-AMT10 Series Assembly Instructions Guide Step 1 1. Insert Tool A as a spacer that defines the distance to the mounting surface. 2. Slide appropriate sized Sleeve over shaft all the way down to Tool A. 3. Slide Shaft Adapter over Sleeve.
- Page 2 Step 4 1. Fasten the Base on the motor. 2. Remove Tool B. Step 5 1. Slide the Top Cover onto the Base, carefully observing that the teeth of the Shaft Adapter align with the grooves in the hub.* We recommend no more than three cycles of mounting and removal of the AMT top cover base.
Need help?
Do you have a question about the ENC-AMT10 Series and is the answer not in the manual?
Questions and answers