Table of Contents
Advertisement
Troubleshooting
Fault
Water changes color or becomes
cloudy.
Rowing stroke return too light.
Computer screen illuminates, but
does not register when rowing.
The Hydro Rower computer does
not illuminate after battery
installation.
The Hydro Rower computer
display is erratic while displaying
SPM and 500 meter times.
Probable Cause
Rower is in direct sunlight or has
not had water treatment.
Bungee not under enough
tension.
Loose or failed
connection/Sensor gap too wide
(see erratic computer display).
Batteries installed incorrectly or
need replacing.
Gap between sensor and
magnetic ring is too wide.
Page 20 of 25
Solution
Change rower location to reduce direct exposure to sunlight. Add
1x Water Treatment Tablet or change tank water as directed in the
water treatment section of this manual.
Tighten by small increments using the bungee tie off tab point and
test tension by allowing the rowing handle to return to its furthest
point forward while still having some slight tension. Note: Light
fraying of the bungee cord is normal.
Check that the computer lead is connected properly. If connected
properly check sensor gap. Contact your local service center if this
fails to address the problem.
Reinstall batteries in correct position and try again. If the LCD screen
fails to illuminate, try rotating the batteries slightly in the computer.
If this fails, contact your local service center.
Adjust sensor location using rear sliding adjustment located near
timing pulley.
Advertisement
Table of Contents
