Troubleshooting - KRESS KUE11 Safety And Operating Manual

TROUBLE SHOOTING
Symptom
Tool will not start when
operating the on/off trigger.
Cutting depth is less than
that is set.
Blade spins or slips
Blade will not cut a straight
line.
Blade kicks back when
beginning a cut
14
Lithium-Ion brushless circular saw
Possible Causes
Battery pack not plugged in.
Battery pack powered off.
Sawdust accumulated at the rear
of the base.
Blade is not tightly engaged with
the spindle.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided properly.
Saw blade teeth may be engaged
in the material when starting.
Blade is not spinning fast enough
KUE11 KUE11.9
Possible Solution
Check to make sure battery pack is connected
well into a working outlet.
Charging the battery.
Shake out sawdust. Consider connecting a
vacuum for dust collection.
Remove the blade and reassemble it as
described in Mounting and Removing the Blade
section.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use a parallel guide.
Before restarting a saw in the workpiece, center
the saw blade in the kerf and check that the saw
teeth are not engaged into the material.
Allow the saw blade to reach full speed prior to
beginning a cut in the material.
Positec Australia Pty Limited
10 Corporate Blvd Bayswater, VIC 3153, Australia