Casanoov TANKER B700 Manual page 13

EN
Construction Drill and Bolts
1) Choose the correct dimensioins of the motors and position to be installed.
2) Check if the mounting surface the brackets to be installed is smooth, vertical and rigid.
3) Arrange the cable conduit for power supply cable of the motors.
4) In order to obtain the optimal supporting from the rear plate, please assemble two post brackes
and one rear metal plast according to below photo
5) Loosen the two screws and remove the back cover of the motor as shown in photo
6) Place the leaves in the closed position
7) Refer to the distance of "B" in the table of opening degree. Place the rear plate in the coorect po-
sition on the mounting surface. Inspect if the distance is proper : the distance between front plate of
the motor and rear plated is 836mm, the difference in height is 21.2mm.
8) Place two post brackets on the surface to be installed and mark the drilling points, then drill mi-
nimum diameter of 8mm holes by four on the mounting surface to be installed and fasten up the
brackets with screws and washers
9) Please make sure the front plate is completely installed horizontally
10) Refer to image below. The distance between front plate of the motor and rear plated is 836mm,
the difference in height is 21.2mm
13