Activating Wi-Fi On The Appliance; Deactivating Wi-Fi On The Appliance; Software Update; Resetting The Appliance Network Settings - Bosch WAV28KHXGC User Manual And Installation Instructions

en Home Connect
Requirement: The smart energy sys-
tem (energy manager) cannot start
your appliance until it is connected to
the appliance.
Set the programme you require.
1.
Press Ready In to set the required
2.
time.
Press Start / Reload
3.
Press Remote Start ⁠ .
4.
a The display shows
Start is activated. The appliance
waits to be started by the smart
energy system (energy manager).
a If the time changes on the display,
e.g. to 8 h, the smart energy sys-
tem (energy manager) has estab-
lished a time at which your appli-
ance can start.
a If the smart energy system (energy
manager) does not start the appli-
ance within the set time, the appli-
ance will start the programme itself
before the set time period ends.
The programme ends when the
time period ends.
Note
Flex Start is deactivated for safety
reasons in the following
circumstances:
¡ Press Start / Reload
¡ Open the door.
¡ Switch off the appliance.
¡ Power failure.
16.5 Activating Wi-Fi on the
appliance
Note: When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
Press and hold Remote Start
1.
approx. 3 seconds.
Set the programme to position 4.
2.
a The display shows Con.
46
.
⁠ and Flex
.
for
Press Start / Reload
3.
until the display shows On.
a Wi-Fi is activated.
Note: If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
16.6 Deactivating Wi-Fi on the
appliance
Press and hold Remote Start
1.
at least three seconds.
Set the programme to position 4.
2.
a The display shows Con.
Press Start / Reload
3.
until the display shows OFF.
a Wi-Fi is deactivated.
Note: If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.
16.7 Software update
Requirement: The display shows
UPd.
Press and hold Remote Start
1.
approx. 3 seconds.
Set the programme to position 6.
2.
a UPd appears on the display.
Press Start / Reload
3.
a The software update is installed.
a If End is shown on the display, the
software update is installed.
Note: The software update may take
several minutes. Do not switch off the
appliance while the software update
is in progress.
16.8 Resetting the appliance
network settings
Press and hold Remote Start
1.
at least 3 seconds.
repeatedly
for
repeatedly
for
.
for