Table of Contents
Advertisement
24 Installing the Hardware and Software
4
5
6
7
8
9
10 Set the resolution (Screen area), and color depth that best suit
11 Click the Advanced button and select the Monitor tab.
12 Set the refresh rate for the monitor connected to the Fire GL
13 Click OK until you are on the Windows desktop.
Note
Click the button corresponding to the type of installation you
want. If you select Custom, a list of software components will
be displayed. Select the check boxes to specify the components
you want to install.
Click Next to continue the installation.
When the ATI FGL Install dialog displays the components to be
installed click on Next. (Depending on which components you
chose different windows might appear. Click on the
corresponding buttons to continue the installation.)
When the Installation complete message appears click Next
again. This will restart your computer.
After Windows 2000/Windows XP reboots, the Found New
Hardware message displays the Digital Signature Not
Found dialog and prompts you Do you want to continue
the installation? Click Yes to install and start the drivers.
Click Start > Settings > Control Panel > Display >
Settings, or right-click on the Windows desktop, select
Properties and Settings.
your requirements and your monitor's performance.
8800 graphics accelerator in your system.
Note: If you have two monitors connected this setting applies to
the monitor connected to the VGA connector. Use the
Monitor
DualScreen
and
settings in a dual-monitor configuration.
Refer to your Windows online help and documentation for
further information on using the Monitor and Settings
dialogs.
dialogs to adapt each monitor's
ATI
Advertisement
Table of Contents
